Preparing the ribs

Adjust  ribs thickness with toothed blade plane and scraper

About the use of the scraper for ribs thickness

Use of the inside form according to the classic cremonese method

0) Ribs making from start to finish (condensed)

1) Preparing of blocks and gluing to the form

2) Tracing of the blocks

3) Roughing the curves of the upper, lower and C side corner blocks

4) Finishing the curves of the C blocks

5) Bending the C ribs

6) Gluing of the C ribs

7) Roughing the curves of the corners

8) Finishing  the  curves of the corners

9) Finishing of the curves of  upper and lower blocks

10) Bending  of upper and lower ribs

11) Gluing of upper and lower ribs

12) Setting of heights and tilts of the ribs

13) Preparing and bending the linings

14) Gluing the linings on both sides of the ribs

15) Finishing of the ribs – part one

16) Finishing of the ribs – part two

17) Finishing the inside of the ribs part one – Removal of the form

18) Finishing the inside of the ribs part two – Finishing of the blocks

19) Finishing the inside of the ribs part three – Finishing of the linings